Floor Assembly

Perimeter frame in 130 x 100 x 3m cold formed “Z” section (100 x 50 RSC on 32 x 10 units), to this frame the 100 x 40 x 3 cold formed joists are welded at 406mm centres. The floor is completed with 15mm T&G Plywood tec screwed to the joists and 2mm vinyl with welded seams is fully bonded to the plywood. Note:- Insulated floors are only standard on 32’ x 10’ units.

Corner Columns

The corner columns are manufactured from 3mm cold formed sections welded to the floor assembly, wall panels and roof perimeter frame.

Walls and Roof

The wall panels are1.6mm thick deeply profiled steel sheets seam welded to each other, the floor assembly and the corner columns. The roof sheets are also 1.6mm this profiled steel, seam welded to the 100 x 8 roof perimeter frame and to each other.

Finishes

The unit is spray painted, inside and out using a corrosion resistant hi build vinyl paint to a dry film thickness of 80-100 microns.

Door

The full width double doors are manufactured from 3mm coldformed steel, security is provided by 2No 5 lever locks, security hinge pins to each leaf, and additional reinforcement to the lock side to provide anti-jemmy protection. The doors have chains to hold them open and two sprin loaded bolts secure the fixed leaf.

Electrics

The electrical wiring is carried on cable trays with metal clad fittings. The consumer unit is fitted with m.c.b’s and RCCD and all electrics are installed in compliance with the latest I.E.E regulations. A test certificate is provided for each unit.